Sonifex Software
S0 Firmware Versions
V1.022
- Fixed channel swap on USB audio input.
V1.021
- Fixed remote handling and on-board configuration for input 3 on channel 9 when Skype mode enabled.
V1.020
- Fixed line hold LED going off when incoming call answered.
V1.019
- Added MCU specific message on failure to read fader state.
- Added 100 ms delay between MCU checks at boot up to stop older revision mix PCBs locking up.
V1.018
- Re-instated aux input on channel 5 for Skype mode which was previously limited to line1 and line2. Audio input is via top panel aux connector
V1.017
- Enabled clean feed output regardless of channel 9 mode
- Fixed bug where presenter split PFL would not turn off if presenter auto PFL was disabled
V1.016
- Merged Skype build into standard firmware with option to enable/disable via power up option
V1.015
- New/Modified USB Serial Commands:
- Added new STAC command to read status on all channels
- Added input 3 to STAC command and notifications
- Added new notifications for PGM, REC and PFL
V1.013
- Added option to Skype build to allow PGM and REC bus to be selected/deselected when the fader is open
V1.012
- Added Skype build which routes Skype calls through channel 9
V1.011
- Added MicLine input mode on channels 1-4 (line input that emulates mic function)
V1.010
- Added indication of mcu state read on boot-up through USB serial port
V1.009
- Added indication of mcu program state on boot-up through USB serial port
- Added USB serial command to restore default states
V1.008
- Fixed failure to enable phantom power on channels 1-4 when select in SCi
- Fixed configuration of meter type at startup
- Changed meter sampling code
- Made meter variables volatile
- Fixed ADC initialization issue created in previous version
- Move position of check for USB serial board to allow PSU to stabilize
- Fixed control states on power up and after loading a new configuration
V1.001
- Prevented PFL selection on channels 5-8 when input 3 selected and USB PFL mode is enabled.
V1.000
- Initial release.
