Signal Converters

RB-SM2

Dual Stereo to Mono Converter

The RB-SM2 is a dual version of the RB-SM1, consisting of two independent converters which will produce two fully buffered and balanced mono line outputs from two stereo inputs.

RK1_logo-optimized RK2_logo-optimized

About RB-SM2

The RB-SM2 is a dual version of the RB-SM1, consisting of two independent converters which will produce two fully buffered and balanced mono line outputs from two stereo inputs.

All connections are on the rear panel. The XLR-3 inputs are electronically balanced with an impedance of 20kΩ bridging. These can be wired unbalanced to accept an output from domestic equipment.

The XLR-3 line outputs are electronically balanced with an output impedance of <50Ω. The outputs can be wired unbalanced by grounding the non-phase signal, allowing you to feed both balanced and unbalanced equipment.

Output gain adjustment using pre-set potentiometers for both converters allows a normalised mono output from domestic stereo equipment. The potentiometers are accessible through the rear panel.

Typical Applications

To supply cue in broadcast environments, to make a mono feed for AM transmission, or to feed a mono PA system.

Product Data

Technical Specifications

Audio Specification
Maximum Input Level:
+28dBu
Maximum Output Level:
+28dBu
Input Impedance:
>20kΩ balanced bridging
Output Impedance:
<50Ω balanced
Frequency Response:
20Hz to 20kHz ±0.1dB (600Ω load, ref 1kHz)
Gain Range:
Adjust -8dB to +18dB gain, ref. 0dB input on L and R
Common Mode Rejection:
>66dB typically
Distortion:
0.01% THD @ 1kHz, ref +8dBu output
Noise:
-100dB, unity gain, ref +8dBu output
Connections
Inputs:
4 x XLR 3 pin female (Balanced, can be unbalanced)
Outputs:
2 x XLR 3 pin male (Balanced, can be unbalanced)
Mains Input:
Filtered IEC, switchable 110-120V, or 220-240V, fused, 6W max
Fuse Rating:
Anti-surge fuse 100mA 20 x 5mm (230VAC)
Fuse Rating:
Anti-surge fuse 250mA 20 x 5mm (115VAC)
Equipment Type
RB-SM2
Dual stereo to mono converter
Physical Specification
Dimensions (Raw):
28cm (W) x 10.8cm (D) x 4.2cm (H) (1U)
Dimensions (Raw):
11” (W) x 4.3” (D) x 1.7” (H) (1U)
Dimensions (Boxed):
36cm (W) x 20.5cm (D) x 6cm (H)
Dimensions (Boxed):
14.2” (W) x 8” (D) x 2.4” (H)
Weight:
Nett: 1.05kg Gross: 1.50kg
Weight:
Nett: 2.3lbs  Gross: 3.3lbs

Downloads & Resources

Support

Handbooks & Guides

RB-SM2 HandbookDownload ↗

Firmware

No firmware currently listed.

Firmware Notes

Full release notes for all firmware versions will appear here when available.

Brochures

Brochures, guides and supporting literature are available from the Sonifex brochures library.Visit brochures page ↗

Declarations

Access CE and UKCA declarations and other product compliance documentation.Visit declarations page ↗