Monitor-Mixer

AVN-PXH12

12 x 2 Channel Monitor-Mixer, AoIP Portal

The Sonifex AVN-PXH12 is a monitor-mixer primarily designed for monitoring Audio Over IP audio channels in a compact 1U format rack.

WEB_logo-optimized AES67_logo-optimized Ravenna_logo-optimized Ember_logo-optimized

About AVN-PXH12

The Sonifex AVN-PXH12 is a compact 1U monitor-mixer designed for Audio over IP (AoIP) applications. It enables AES67-compatible streams on your network to be assigned to channels and mixed down to analogue outputs, headphones, and an integrated speaker.

The unit supports monitoring of up to 12 sources simultaneously, selected from a total pool of 24 inputs. These sources can be drawn from four stereo analogue inputs; one front-panel 3.5mm jack, two rear-panel 3.5mm jacks, and one rear-panel stereo XLR pair, or from RAVENNA, AES67, and AES67-enabled Dante® streams.

Signals are assigned to 12 front-panel control channels, each offering ‘Normal’ and ‘Alternate’ source selection. Every channel features three buttons for source selection, muting, and routing to left, right, or stereo outputs. A rotary control adjusts level and provides visual feedback via green, amber, or red illumination to indicate signal level. Pressing the control activates a solo function for that channel.

Front-panel LEDs display network, synchronisation, and power supply status. Monitoring is available via parallel stereo headphone outputs on 6.35mm (¼”) and 3.5mm jacks, each with independent attenuation, along with a mono speaker output. Dedicated level controls are provided for both headphones and speaker, with an additional mute function for the speaker.

On the rear panel, three line-level XLR outputs can be configured as mono mix, stereo left/right, or assigned to specific input sources. The unit can also transmit the four stereo analogue inputs (eight channels) as AES67 streams, along with a stereo mix derived from the speaker output.

The AVN-PXH12 supports IEEE1588-2008 PTPv2 (media and default profiles) and can operate as either a master or follower clock. Dual power inputs (IEC mains and DC) provide redundancy. Network connectivity includes separate Ethernet ports for control and AoIP, plus an SFP interface that can replace the AoIP RJ45 connection when required.

A GPIO connector offers 10 configurable ports for external control, alongside a voltage-free relay for interfacing with other equipment. Configuration, source routing, firmware updates, and backup are handled via an integrated web server, while external control is available using Ember+.

The built-in web interface provides an intuitive environment for setup and configuration. It is fully responsive, adapting to different screen sizes for use on both desktop and mobile devices. Context-sensitive help is displayed on-screen, making it easy to understand and operate the unit.

Typical Applications

Production gallery or control room channel monitoring positions, OB truck monitoring, confidence channel monitoring of any AoIP installation.

Product Data

Technical Specifications

Audio-Over-IP Specification
Open Standards:
RAVENNA, AES67
Device Discovery:
Bonjour (mDNS / DNS-SD) & SAP
Audio Delivery:
RTP/UDP over IPv4 multicast
QoS:
DiffServ
Stream Management:
RTSP/SDP
Control:
Ember+/webserver
Format:
Linear PCM 24-bit (L24)
Channels Per Stream:
Maximum of 8
Frames Per Packet:
48
Maximum Streams:
RX 15, TX 2
Sample Rate:
48 kHz
Timing Synchronisation
Profile Support:
Default, media & custom profiles
Timing Protocol:
PTPv2, IEEE1588-2008
Unbalanced Line Inputs
Input Impedance:
>20kΩ
0dBFS Line-Up:
+12dBu
Frequency Response:
20Hz to 20kHz, +0/-0.2dB
THD+N:
<-97dBFS, -30dBFS, 20Hz to 20kHz, unity gain, 20kHz BW
Noise:
-100dBFS, 20kHz BW, Rs=200Ω
Crosstalk:
<-97dB
Balanced Line Inputs
Input Impedance:
>20kΩ balanced
0dBFS Line-Up:
Adjustable +15/+18/+20/+22/ +24dBu
Frequency Response:
20Hz to 20kHz, +0/-0.2dB
THD+N:
<-110dBFS, -30dBFS, 20Hz to 20kHz, 20kHz BW
Noise:
-110dBFS, 20kHz BW, Rs=200Ω
Crosstalk:
<-100dB
Common Mode Rejection:
>70dB @ 1kHz
Headphone Output
Output Impedance:
Drives 150mW into 32Ω to 600Ω headphones
0dBFS Line-Up:
+20dBu
Frequency Response:
20Hz to 20kHz, +0/-0.2dB
THD+N:
<-108dBFS, -30dBFS, 20Hz to 20kHz, unity gain, 20kHz BW
Noise:
-110dBFS, 20kHz BW
Balanced Line Outputs
Output Impedance:
<50Ω balanced
0dBFS Line-Up:
Adjustable +15/+18/+20/+22/ +24dBu
Frequency Response:
20Hz to 20kHz, +0/-0.2dB
THD+N:
<-110dBFS, -30dBFS, 20Hz to 20kHz, 20kHz BW
Noise:
-110dBFS, 20kHz BW, Rs=200Ω
Loudspeaker
Power Output:
4W
Volume:
Mute to full volume via front panel control
Connections
Headphone:
¼ inch (6.35mm) stereo jack socket
Headphone:
3.5mm stereo jack socket
Audio Inputs:
3 x unbalanced 3.5mm stereo jack socket
Audio Inputs:
2 x balanced XLR-3 female socket
Audio Outputs:
3 x balanced XLR-3 male plug
Audio Outputs:
1 x loudspeaker output
GPIO:
15-way ‘D’-type socket
Network:
2 x gigabit Ethernet, RJ45
Network:
1 x SFP fibre
Equipment Type
AVN-PXH12:
2 x 12 Channel mix monitor, AoIP portal
Physical Specification
Dimensions: (Raw)
48.3cm (W) x 20.12cm (D) x 4.4cm (H)(1U)
Dimensions: (Raw)
19” (W) x 7.92” (D) x 1.8” (H) (1U)
Dimensions (Boxed):
55.2cm (W) x 29.5cm (D) x 16.5cm (H)
Dimensions (Boxed):
21.7" (W) x 11.6" (D) x 6.5" (H)
Weight:
Nett: 2.9kg   Gross: 3.5kg
Weight:
Nett: 6.38lbs  Gross: 7.7lbs
Accessories
AVN-DC150:
150W DC power supply with KPJX-4S plug

Downloads & Resources

Support

Handbooks & Guides

AVN-PXH12 HandbookDownload ↗
The AVN GuideDownload ↗
AVN-PXH12 Ember+ ReferenceDownload ↗

Firmware

AVN-PXH12
Version 3.5.3007 · 19/05/2006
Download ↗
Service Discovery (find device IP addresses on your local network)
Download ↗

Firmware Notes

Full release notes for all firmware versionsDownload ↗

Brochures

Brochures, guides and supporting literature are available from the Sonifex brochures library.Visit brochures page ↗

Declarations

Access CE and UKCA declarations and other product compliance documentation.Visit declarations page ↗